16010 Image IMAGE: Total mainscan shift too large All The net mainscan shift is calculated from the following parameters: "set gc mss" - nominal shift, the same for all recorders of the same model "set gc mssa" - adjustment made during integration "set mode <mode> mssa" - the workstation can overwrite this shift with a new one for each image The values of the "gc" parameters should be compared to the factory settings. If these settings are not the problem, the workstation must have sent a large positive mainscan shift. This should be found and adjusted. The maximum mainscan shift is equal to 4096 pixels, i.e. 2.56 inches in 1600 DPI, 1.7 inches in 2400 DPI, and 1.28 inches in 3200 DPI. Record error message and contact Creo Service "set gc mss", "set gc mssa", and/or "set mode <mode> mssa" shift parameters are incorrect Workstation is specifying a large positive shift around the drum. ../nvs/gc_cfg_mss.xmlNVS: gc mss ../nvs/gc_cal_mssa.xmlNVS: gc mssa ../nvs/mode_cal_mssa.xmlNVS: mode mssa ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:27 2008 PST